The following sections of this BookRags Literature Study Guide is offprint from Gale's For Students Series: Presenting Analysis, Context, and Criticism on Commonly Studied Works: Introduction, Author Biography, Plot Summary, Characters, Themes, Style, Historical Context, Critical Overview, Criticism and Critical Essays, Media Adaptations, Topics for Further Study, Compare & Contrast, What Do I Read Next?, For Further Study, and Sources.
(c)1998-2002; (c)2002 by Gale. Gale is an imprint of The Gale Group, Inc., a division of Thomson Learning, Inc. Gale and Design and Thomson Learning are trademarks used herein under license.
The following sections, if they exist, are offprint from Beacham's Encyclopedia of Popular Fiction: "Social Concerns", "Thematic Overview", "Techniques", "Literary Precedents", "Key Questions", "Related Titles", "Adaptations", "Related Web Sites". (c)1994-2005, by Walton Beacham.
The following sections, if they exist, are offprint from Beacham's Guide to Literature for Young Adults: "About the Author", "Overview", "Setting", "Literary Qualities", "Social Sensitivity", "Topics for Discussion", "Ideas for Reports and Papers". (c)1994-2005, by Walton Beacham.
All other sections in this Literature Study Guide are owned and copyrighted by BookRags, Inc.
As long ago as 1889, E. Martin worked on a rudimentary signal system that would enhance automobile and road safety. He thought of using a board mounted to the back of his vehicle with a set of flaps that would conceal the word STOP. When the brakes were applied, the flaps would open to reveal the message to those following him. With the development of four-wheel braking systems and electrical systems, a switch was connected to a brake rod in such a way that, when the brakes were applied, a red lamp at the rear would light. Later, the use of hydraulic brakes changed the system so that the switch was made sensitive to pressure in the brake line.
Features were added to this system to enable the driver to denote turns as well as stops. In 1893, J. B. Freeman employed a roller at the back of the car which was attached to a cord and could indicate STOP, LEFT, and RIGHT. Other inventors created mechanical arms that swung out on either side of the car when the driver operated a control. Just after the turn of the century, such signals were pneumatically operated and self-canceling, thanks to F. Berger. In 1908, Alfredo Barrachini used separate semaphore arms that were lit by small electric bulbs.
The next step was the use of flashing lights to indicate turns. Several designers used flashing lights in semaphores and other early indicators. H. G. Wheeler devised a small motor to make the lights blink, while a Vermont company used a pneumatic device that worked from engine suction to flash the lights. Inventors at a Delaware corporation realized, in 1935, that a device called a thermal interrupter switch could also be used to trigger flashing car lights. In this switch, a tension wire heats up as electricity flows through it; it then expands and allows current to pass to the bulb. This short-circuits the wire, which then cools off enough to shrink and break off the contact to the bulb. In 1962, John Ridout and Frank Hill made a flasher circuit that used transistors for the first time. Microprocessors activate brake lights and directional signals in cars of the 1990s; sizes and locations of these safety devices have been modified to include a centrally located and elevated brake light and turn, reverse, and brake lights that are generally larger than those of earlier models.