 |
It has been suggested that this article or section be merged with bend radius. () |
The minimum bend radius is the radius below which an object such as a cable should not be bent. The minimum bend radius is of particular importance in the handling of fiber-optic cables, which are often used in telecommunications. The minimum bending radius will vary with different cable designs. The manufacturer should specify the minimum radius to which the cable may safely be bent during installation, and for the long term. The former is somewhat shorter than the latter. The minimum bend radius is in general also a function of tensile stresses, e.g., during installation, while being bent around a sheave while the fiber or cable is under tension. If no minimum bend radius is specified, one is usually safe in assuming a minimum long-term low-stress radius not less than 15 times the cable diameter. Beside mechanical destruction, other reason why one should avoid excessive bending is to minimize microbending macrobending losses. Microbending losses are light attenuation that are induced by deformity (clinks) on the fibre while macrobending are the lickage of light through the fibre cranding and this is more likely to happen where the fibre is excessively bent. Besides for cables, strain gauges also have a minimum bending radius. This radius is the radius below the strain gauge which will cause the malfunction of the gauge.
See also
This article contains material from the Federal Standard 1037C, which, as a work of the United States Government, is in the public domain.
