Delta-v

In astrodynamics delta-v is a scalar which takes units of speed that measures the amount of "effort" needed to carry out an orbital maneuver, i.e., to change from one trajectory to another.

<math>\Delta{v} = \int_{t} {\frac {|T|} {m}}\, dt</math>

Where

<math>T</math> is the instantaneous thrust

<math>m</math> is the instantaneous mass

In the absence of external forces, and when thrust is applied in a constant direction this simplifies to:

<math>= \int_{t} {|a|}\, dt = | {v}_1 - {v}_0 |</math>

which is simply the magnitude of the change in velocity.

Delta-v's used for trajectories

When designing a trajectory, delta-v is used as an indicator of how much fuel will be required. Actual fuel usage depends much more than linearly on delta-v according to the rocket equation. It is not possible to determine delta-v requirements from conservation of energy by considering only the total energy of the vehicle in the initial and final orbits since the propellant carries energy away in the exhaust (see also below); as well as propellant being used up in a burn. For example, most spacecraft are launched in an orbit with inclination fairly near to the latitude at the launch site, to take advantage of the earth's rotational surface speed. If it is necessary, for mission-based reasons, to put the spacecraft in an orbit of different inclination, a substantial delta-v is required, though the specific kinetic and potential energies in the final orbit and the launch orbit are equal. When rocket thrust is applied in short bursts the other sources of acceleration may be negligible, and the magnitude of the velocity change of one burst may be simply approximated by the delta-v. The total delta-v to be applied can then simply be found by addition of each of the delta-vs needed at the discrete burns, even though between bursts the magnitude and direction of the velocity changes due to gravity, e.g. in an elliptic orbit. For examples of calculating Delta-v, see Hohmann transfer orbit, gravitational slingshot, and Interplanetary Superhighway. It is also notable that large thrust can reduce gravity drag. Delta-v is also required to keep satellites in orbit and is expended in orbital stationkeeping maneuvers. Since most satellites cannot be refueled, the fuel may well determine the useful lifetime of a satellite.

Oberth effect

When applying delta-v in the direction of the velocity the specific orbital energy gained per unit delta-v is equal to the instantaneous speed. For a burst of thrust during which both the acceleration produced by the thrust and the gravity are constant, the specific orbital energy gained per unit delta-v is the mean value of the speed before and the speed after the burst. Thus for example the energy of a satellite in an elliptic orbit is boosted more efficiently at high speed (i.e., small altitude) than at low speed (i.e., high altitude). This is called the Oberth effect. See also powered slingshotshttp://linux11763.dn.net/Gravitational_slingshot#Powered_slingshots.

Porkchop plot

Due to the relative positions of planets changing over time, different delta-vs are required at different launch dates. A diagram that shows the required delta-v plotted against time is sometimes called a Porkchop plot. Such a diagram is useful since it enables calculation of a launch window, since launch should only occur when the mission is within the capabilities of the vehicle to be employed.^[1]

Producing Delta-v

Delta-v is typically provided by the thrust of a rocket engine, but can be created by other reaction engines. The time-rate of change of delta-v is the magnitude of the acceleration caused by the engines, i.e., the thrust per total vehicle mass. The actual acceleration vector would be found by adding thrust per mass on to the gravity vector and the vectors representing any other forces acting on the object. The total delta-v needed is a good starting point for early design decisions since consideration of the added complexities are deferred to later times in the design process. The rocket equation shows that the required amount of propellant dramatically increases, with increasing delta-v. Therefore in modern spacecraft propulsion systems considerable study is put into reducing the total delta-v needed for a given spaceflight, as well as designing spacecraft that are capable of producing a large delta-v. Increasing the Delta-v provided by a propulsion system can be achieved by:

• staging
• increasing specific impulse
• improving mass fraction

Additionally raising thrust levels (when close to a gravitating body) can sometimes improve delta-v.

Delta-vs around the Solar System

Delta-vs in km/s for various orbital manoeuvers^[2][3] using conventional rockets. Red arrows show where optional aerobraking can be performed in that particular direction, black numbers give delta-v in km/s that apply in either direction. Lower delta-v transfers than shown can often be achieved, but involve rare transfer windows or take significantly longer, see: fuzzy orbital transfers. Not all possible links are shown.

Abbreviations used

See also

• Delta-v budget
• Gravity drag
• Orbital maneuver
• Orbital stationkeeping
• Spacecraft propulsion
• Specific impulse
• Tsiolkovsky rocket equation

References

1. ^ [1]
2. ^ table of cislunar/mars delta-vs
3. ^ cislunar delta-vs